Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › INTAKE MANIFOLD › from 2016.01
RM3270E _51 Engine / Hybrid System _048934 2KD-FTV INTAKE / EXHAUST _0244726 INTAKE MANIFOLD A

2KD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 26100G 3.REMOVE DIESEL THROTTLE BODY ASSEMBLY

Hide 17118 4.REMOVE MANIFOLD STAY

a.
A345132

Remove the 2 bolts and manifold stay from the cylinder head sub-assembly and cylinder block sub-assembly.


Hide 11452 5.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Remove the engine oil level dipstick.


b.
A345133

Remove the bolt and injection pipe clamp.


c.

Remove the bolt and engine oil level dipstick guide.


d.

Remove the O-ring from the engine oil level dipstick guide.


Hide 25861C 6.REMOVE VACUUM SWITCHING VALVE BRACKET

a.
A233088

Remove the 2 bolts and vacuum switching valve bracket.


Hide 17873A 7.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET

a.
A114779

Remove the 3 bolts and No. 2 intake air connector bracket from the cylinder head sub-assembly and intake manifold.


Hide 17861F 8.REMOVE INTAKE AIR CONNECTOR

a.

Remove the 2 nuts, bolt and intake air connector from the intake manifold.


Hide 23701 9.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 23704 10.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 23770 11.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

Hide 17111 12.REMOVE INTAKE MANIFOLD

a.
A131656

Remove the 4 bolts, 2 nuts, intake manifold and gasket.