The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0122 | Lost Communication with Vehicle Dynamics Control Module | While vehicle speed is 40 km/h (25 mph) or more and cruise control main switch (ON/OFF) is on, data cannot be received from skid control ECU (brake actuator assembly) for 2.5 seconds or more. | ·
Skid control ECU (brake actuator assembly) ·
CAN communication system ·
ECM |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON/OFF).
Push the cruise control main switch to -/SET to begin control of vehicle speed using the cruise control system.
Check the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0122 is not output | A |
| DTC U0122 is output (for LHD) | B |
| DTC U0122 is output (for RHD) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C