This DTC is output when a malfunction in the L4 detection switch is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P2772 | Four Wheel Drive (4WD) Low Switch Circuit Range / Performance | ·
Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) ·
Malfunction Status: L4 detection switch is stuck OFF when the vehicle is in L4 ·
Malfunction Time: 10 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer shift actuator assembly |
Disconnect the C60 4 wheel drive control ECU connector.
Disconnect the C74 transfer shift actuator assembly connector.
w/o VSC:
Disconnect the A68 skid control ECU (brake actuator assembly) connector.
w/ VSC:
Disconnect the A4 skid control ECU (brake actuator assembly) connector.
for 1GD-FTV, 2GD-FTV:
Disconnect the C41 ECM connector.
for 1GR-FE:
Disconnect the G144 ECM connector.
for 2TR-FE:
Disconnect the G143 ECM connector.
for 1KD-FTV (Automatic Transmission):
Disconnect the G146 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C60-3 (4WDL) - C74-9 (L4) | Always | Below 1 Ω |
| C74-10 (GND) - Body ground | Always | Below 1 Ω |
| C60-3 (4WDL) or C74-9 (L4) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch to ON.
Turn the transfer position switch to L4.
Turn the ignition switch off.
Disconnect the C74 transfer shift actuator assembly connector.
| *a | Component without harness connected
(Transfer Shift Actuator Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (L4) - 10 (GND) | Transfer L4 | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG