Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR DRIVE UNIT › from 2016.01
RM3270E _59 Vehicle Exterior _041717 DOOR / HATCH _0205112 POWER BACK DOOR DRIVE UNIT A

DOOR / HATCH  POWER BACK DOOR DRIVE UNIT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 68946 1.INSTALL UPPER BACK DOOR DAMPER STAY BRACKET LH

a.

Clean the threaded portion on the vehicle body with non-residue solvent.


b.
B426543N01
1.792,0.448 1.948,0.646 0.156,0.198 10 true 2 1.74,1.625 1.896,1.823 0.156,0.198 10 true 1

Temporarily install the upper back door damper stay bracket LH.


c.

Tighten 2 new bolts to install the upper back door damper stay bracket LH.

HINT:

Tighten the 2 bolts in the order shown in the illustration.


Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68948 2.INSTALL LOWER BACK DOOR DAMPER STAY BRACKET LH

a.

Clean the threaded portion on the back door panel with non-residue solvent.


b.
B426544N01
1.031,0.667 1.188,0.865 0.156,0.198 10 true 1 2.135,0.49 2.292,0.688 0.156,0.198 10 true 2

Temporarily install the lower back door damper stay bracket LH.


c.

Tighten 2 new bolts to install the lower back door damper stay bracket LH.

HINT:

Tighten the 2 bolts in the order shown in the illustration.


Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68920 3.INSTALL POWER BACK DOOR UNIT ASSEMBLY LH

NOTICE:

Do not apply any horizontal load to the power back door unit set assembly in order to prevent the pistion rod from deforming.


a.
B426546

Attach the 2 ball joints to install a new power back door unit assembly LH.

NOTICE:
·

Install the power back door unit assembly while supporting the back door by hand.

·

Check that the back door stay assembly is engaged in the ball joint and that the back door support assembly cannot be pulled out.




b.

Attach the grommet.


c.
B408701

Connect the connector.


Hide 84280D 4.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH