The combination meter assembly sends an auto dimmer signal to the radio receiver assembly via this circuit.
When the radio receiver assembly receives an auto dimmer signal from the combination meter assembly, the panel switch of the radio receiver assembly dims and the screen changes to the night screen.
When replacing the combination meter assembly, make sure to replace it with a new one.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
Disconnect the radio receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G171-3 (ADIM) - Body ground | Ignition switch ON, automatic light control sensor covered by hand, and light control switch in tail or head position | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G171 radio receiver assembly connector.
Disconnect the G8 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G171-3 (ADIM) - G8-4 (ACAN) | Always | Below 1 Ω |
| G171-3 (ADIM) or G8-4 (ACAN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG