Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below are for RHD vehicles.
75740
1.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH
|
Install in this Direction |
Attach the claw to install a new rear door belt moulding assembly LH as shown in the illustration.
Remove the protective tape.
75724
2.INSTALL REAR DOOR REAR BELT MOULDING LH
|
Install in this Direction |
Attach the clip to install the rear door rear belt moulding LH.
68124C
3.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68104
4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67408E
5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68152C
6.INSTALL REAR DOOR GLASS RUN LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67604
8.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
69284D
9.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
81230
10.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
74260
12.INSTALL REAR ARMREST ASSEMBLY LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67674A
13.INSTALL REAR DOOR FRAME GARNISH LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION