The integration control and panel assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the integration control and panel assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| B14B3 | Lost Communication with Rear Panel LIN | Lost communication with the integration control and panel assembly. | ·
Harness or connector ·
LIN communication system ·
Integration control and panel assembly ·
Air conditioning amplifier assembly |
Memorized (10 seconds or more) | - |
The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the parentheses.
Inspect the fuses for circuits related to this system before performing the following procedure.
When the servo motor or air conditioning amplifier assembly is replaced, be sure to perform servo motor initialization.
| *a | Front view of wire harness connector
(to Integration Control and Panel Assembly) |
Disconnect the integration control and panel assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N34-5 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| N34-8 (IG+) - Body ground | Engine switch off | Below 1 V |
| N34-8 (IG+) - Body ground | Engine switch on (IG) | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N34 integration control and panel assembly connector.
Disconnect the G37 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N34-6 (LIN1) - G37-37 (LIN1) | Always | Below 1 Ω |
| N34-6 (LIN1) or G37-37 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the integration control and panel assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REAR BLOWER CONTROL SWITCH>REMOVAL
When troubleshooting according to the DTC:
Check for DTCs.
DTC B14B3 is not output.
When troubleshooting according to Problem Symptoms Table:
Check the air conditioning control assembly operates normally.
Since the air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning control assembly with a new or known good one and check that the condition returns to normal.
Air conditioning control assembly operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to the DTC) | B |
| NG (When troubleshooting according to Problem Symptoms Table) | C |
A
B
C