Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
89865
1.INSTALL DOOR SIDE AIRBAG SENSOR RH
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the door side airbag sensor RH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.
Attach the guide and hold the door side airbag sensor RH in place.
Install the bolt.
If the door side airbag sensor RH has been dropped, replace it with a new one.
When installing the door side airbag sensor RH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
Tighten the bolt while holding the door side airbag sensor RH because the door side airbag sensor RH guide is easily damaged.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Before connecting the airbag connector, check that the position of the housing lock is correct as shown in the illustration.
| *a | Incorrect | *b | Correct |
While holding the CPA, be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).
Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | *d | Connection is Completed |
|
Connect in this Direction | - | - |
Check that there is no looseness in the installation parts of the door side airbag sensor RH.
67601
2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
69283
3.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG RH
4.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
5.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
74210
6.INSTALL FRONT ARMREST ASSEMBLY RH
67491A
7.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH RH
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
9.PERFORM DIAGNOSTIC SYSTEM CHECK
10.CHECK SRS WARNING LIGHT