Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › from 2016.01
RM3270E _51 Engine / Hybrid System _041679 CRUISE CONTROL _0205136 CRUISE CONTROL MAIN SWITCH A

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for RHD vehicles.



The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the cruise control main switch removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Reset back door close position Power back door system (Click here)

PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45130 3.REMOVE HORN BUTTON ASSEMBLY

Hide 84632 4.REMOVE CRUISE CONTROL MAIN SWITCH

a.
A346023

Remove the 2 screws.


b.

Disconnect the connector and remove the cruise control main switch.


Hide 84633 5.REMOVE CRUISE CONTROL SWITCH WIRE

a.
B338904

Disconnect the connector and remove the cruise control switch wire from the cruise control main switch.