The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat outer belt assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913B
3.REMOVE FRONT DOOR SCUFF PLATE RH
67917C
4.REMOVE REAR DOOR SCUFF PLATE RH
73233
5.REMOVE OUTER LAP BELT ANCHOR COVER
73210
6.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH (Floor Anchor)
Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly RH.
62413A
7.REMOVE LOWER CENTER PILLAR GARNISH RH
73178A
8.REMOVE SEAT BELT ANCHOR COVER CAP
73210
9.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
Remove the bolt and disconnect the shoulder anchor of the front seat outer belt assembly RH.
| *1 | Locking Button |
|
Protective Tape |
Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.
Tape the screwdriver tip before use.
Remove the bolt.
Detach the 2 guides and remove the front seat outer belt assembly RH.
62411B
10.REMOVE UPPER CENTER PILLAR GARNISH RH
73023
11.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY RH
Perform this procedure when replacing the shoulder belt anchor plate sub-assembly RH.
|
Remove in this Direction |
Detach the claw and remove the front shoulder belt anchor plate sub-assembly RH in the illustration.
73135A
12.REMOVE SHOULDER BELT ANCHOR COVER RH
Perform this procedure when replacing the shoulder belt anchor cover RH.
| *1 | Shoulder Belt Anchor Cover RH |
Detach the claw and remove the 2 shoulder belt anchor cover RH.
73200A
13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts.
Detach the guide to remove the front shoulder belt anchor adjuster assembly.