Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
73200A
1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Attach the guide and temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
73135A
2.INSTALL SHOULDER BELT ANCHOR COVER RH
| *1 | Shoulder Belt Anchor Cover RH |
Attach the claw and install the 2 shoulder belt anchor cover RH.
73023
3.INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY RH
Perform this procedure when replacing the shoulder belt anchor cover RH.
|
Install in this Direction |
Attach the claw and install the front shoulder belt anchor plate sub-assembly RH as shown in the illustration.
62411B
4.INSTALL UPPER CENTER PILLAR GARNISH RH
73210
5.INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH
Attach the 2 guides and install the front seat outer belt assembly RH with the bolt.
| *1 | Locking Button |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Connect the shoulder anchor of the front seat outer belt assembly RH with the bolt.
Check that the ELR locks.
The check should be performed with the front seat outer belt assembly RH installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
73178A
6.INSTALL SEAT BELT ANCHOR COVER CAP
62413A
7.INSTALL LOWER CENTER PILLAR GARNISH RH
73210
8.INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH (Floor Anchor)
Connect the floor anchor of the front seat outer belt assembly RH with the bolt.
73233
9.INSTALL OUTER LAP BELT ANCHOR COVER
67917C
10.INSTALL REAR DOOR SCUFF PLATE RH
67913B
11.INSTALL FRONT DOOR SCUFF PLATE RH
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13.CHECK SRS WARNING LIGHT