Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door) › from 2016.01
RM3270E _59 Vehicle Exterior _041716 WINDOW / GLASS _0206017 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 85710D 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.
B405912

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly RH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly RH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



c.
B430662

for Front Passenger Side, w/o Jam Protection Function:

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69801 2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

Hide 68101 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY RH

Hide 68141C 4.INSTALL FRONT DOOR GLASS RUN RH

Hide 67831 5.INSTALL FRONT DOOR SERVICE HOLE COVER RH

Hide 67601 6.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 69283 7.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 8.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 9.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 74210 10.INSTALL FRONT ARMREST ASSEMBLY RH

Hide 67491A 11.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH RH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION