Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.08
RM3270E _53 Suspension _057740 TIRE PRESSURE MONITORING _0287816 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C252619E15
1.073,0.563 3.365,0.76 2.292,0.198 10 false from IG Circuit 3.323,0.74 4.583,1 1.26,0.26 10 false IG1 NO. 4 5.156,0.563 5.469,0.76 0.313,0.198 10 false IG 4.927,0.458 5.26,0.656 0.333,0.198 10 false 1 5.135,1.292 6.667,1.49 1.531,0.198 10 false GND 4.875,1.125 5.208,1.323 0.333,0.198 10 false 12 4.333,1.719 6.167,1.917 1.833,0.198 10 false N54 4.333,1.917 6.906,2.281 2.573,0.365 10 false Tire Pressure Warning ECU and Receiver

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registration Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

Click here



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)
a.

Turn the ignition switch off.


b.
E198671C35
0.25,1.115 0.667,1.385 0.417,0.271 1.24,1.427 0.5,1.583 0.5,1.583 0.5,1.75 true 2.063,1.625 2.49,1.667 true 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 0.313,1.156 0.771,1.354 0.458,0.198 10 false N54 0.448,1.771 0.76,1.969 0.313,0.198 10 false IG 2.573,1.594 3.313,1.771 0.74,0.177 10 false GND
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)


Disconnect the N54 tire pressure warning ECU and receiver connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
N54-1 (IG) - Body ground Ignition switch ON 10 to 16 V
Ignition switch off Below 1 V



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
N54-12 (GND) - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR