Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY(for TMEE (AAV) Made) › from 2017.03
RM3270E _52 Drivetrain _041685 DRIVE SHAFT / PROPELLER SHAFT _0313534 PROPELLER SHAFT ASSEMBLY(for TMEE (AAV) Made) G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY(for TMEE (AAV) Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT

C061260

a.

Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

Maximum Runout:
Item Specified Condition
Propeller shaft 0.3 mm (0.0118 in.)
Intermediate shaft 0.3 mm (0.0118 in.)


If the shaft runout is more than the maximum, replace the shaft.


Hide 2.INSPECT SPIDER

a.

Check the spider bearings for wear or damage.


b.
C172298

Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the bearing axial play is more than the maximum, replace the spider bearing.


Hide 37230 3.INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY

C118618

a.

While turning the center No. 1 support bearing assembly by hand, check that it turns smoothly without catching and that there are no cracks or damage.

If there are any defects, replace the bearing.

If there is any damage to the lip of the center No. 1 support bearing assembly case, replace the bearing.