FUNCTION OF MAIN COMPONENTS
The components have the following functions:
| Component | Function |
|---|---|
| No. 1 Ultrasonic Sensor | Detect the distance between the vehicle and the obstacle. |
| Rear Clearance Warning ECU Assembly | Judges the approximate distance between the vehicle and obstacle based on the signals from the No. 1 ultrasonic sensors and sends the buzzer signal to the No. 1 clearance warning buzzer. |
| No. 1 Clearance Warning Buzzer | Sounds intermittently to inform the driver that the rear clearance warning ECU assembly has detected an obstacle within the prescribed range. |
| Back Sonar or Clearance Sonar Switch Assembly | Turns the TOYOTA parking assist-sensor system on/off. |
| Back-up Light Switch Assembly*1 | Transmits the on/off signals of the back-up light switch assembly to the rear clearance sonar ECU assembly. |
| Park/Neutral Position Switch Assembly*2 | Transmits the R position signal to the rear clearance sonar ECU assembly. |
*1: Models with manual transmission
*2: Models with automatic transmission
SYSTEM CONTROL
After the TOYOTA parking assist-sensor system has started its activation, it sounds the No. 1 clearance warning buzzer for approximately 1 second, while checking for any malfunctions in the No. 1 ultrasonic sensors.
The on and off times of the No. 1 clearance warning buzzer vary as shown in the table below, depending on the distance between the obstacle and the No. 1 ultrasonic sensor:
| Ultrasonic Sensor | Obstacle Distance [mm (in.)] | Off Time (ms) | On Time (ms) | |
|---|---|---|---|---|
| Detection Level | 1st | Approx. 1500 (59.1) to 1000 (39.4) | 150 | 150 |
| 2nd | Approx. 1000 (39.4) to 500 (19.7) | 75 | 75 | |
| 3rd | Approx. 500 (19.7) or less | 0 | Continuous | |
The operating conditions of the ultrasonic sensor are as follows:
| Installation Position | Operating Condition |
|---|---|
| Rear Center | ·
Ignition switch is ON. ·
Back sonar or clearance sonar switch is on. ·
Shift lever is in R. |
DIAGNOSIS
If the system cannot activate its detection function due to a malfunction in an No. 1 ultrasonic sensor, it alerts the driver of the malfunction by sounding the No. 1 clearance warning buzzer. For details, refer to the corresponding Repair Manual for this model.