CONSTRUCTION
A dash panel to cowl brace is used to connect the dash panel and the top of the floor tunnel in order to minimize the vibration of the dash panel.
A brace is used to connect the front body pillar inner panel and the cowl top panel assembly in order to increase the rigidity of the cowl and minimize vibration.
| *1 | Dash Panel to Cowl Brace | *2 | Dash Panel Sub-assembly |
| *3 | Floor Tunnel | *4 | Brace |
| *5 | Cowl Top Panel Assembly | - | - |
The areas on which the cab mounts are mounted use spacers to form a box-shaped construction in order to increase rigidity and minimize the transmission of vibration to the body.
| *1 | No. 1 Cab Mount | *2 | No. 2 Cab Mount |
| *3 | No. 3 Cab Mount | *4 | No. 4 Cab Mount |
| *5 | Body Shell | *6 | Frame Sub-assembly |
| *7 | Cab Mounting Cushion Holder | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | D - D Cross Section |
An asphalt sheet is used to reduce engine and road noise.
| *A | Models for G.C.C. Countries | - | - |
| *1 | Asphalt Sheet (No. 1 Dash Panel Insulator Sheet) | *2 | Asphalt Sheet (Front Floor Silencer Sheet) |
| *3 | Asphalt Sheet (Rear Wheel House Silencer Sheet) | *4 | Asphalt Sheet (No. 1 Rear Floor Silencer Sheet) |
| *5 | Asphalt Sheet (No. 2 Rear Floor Silencer Sheet) | - | - |
On models for South Africa, a hood insulator is provided on the rear of the hood panel. This achieves excellent sound insulation performance.
| *1 | Hood Insulator | - | - |
A dash panel insulator is provided. This insulates and absorbs the engine noise to reduce the engine noise leaking into the cabin.
| *1 | Dash Panel Insulator | - | - |
Sound absorbing materials are applied to the roof panel, pillars and rear quarter panels to reduce wind and road noise.
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | - | - |
|
Foamed Seal Material |
|
Felt |
|
Polypropylene Sheet |
|
Polyurethane Form |
|
Damping Sheet (Right Hand Only) | - | - |
Wind noise has been reduced through the use of the following constructions:
The height offset has been eliminated from the glass, pillars, and the roof to reduce wind noise.
Considering the airflow from the engine hood to the front windshield, the cowl louver and wiper arms have been optimally located to reduce wind noise.
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | - | - |
|
Airflow | - | - |