Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068449 CAMSHAFT OIL CONTROL VALVE G

2TR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.


b.
A123787
2.594,0.302 2.677,0.302 2.677,0.302 2.792,0.635 true 3.135,0.302 3.052,0.302 3.052,0.302 2.917,0.625 true 1,1.479 1.229,0.969 1.229,0.969 1.344,0.969 true 2.469,0.208 2.646,0.417 0.177,0.208 10 false 1 3.167,0.208 3.354,0.417 0.188,0.208 10 false 2 1.375,0.865 1.656,1.063 0.281,0.198 10 false *1 0.177,0.031 0.354,0.188 0.177,0.156 10 false *a
*1 Spool Valve
*a Component without harness connected
(Camshaft Timing Oil Control Valve)


Connect the positive (+) lead of the battery to terminal 1 and negative (-) lead to terminal 2 and check the movement of the spool valve.

OK:
Measurement Condition Specified Condition
Battery positive (+) voltage is applied Valve moves in direction shown by black arrow in illustration
Battery positive (+) voltage is cut off Valve moves in direction shown by white arrow in illustration


If the result is not as specified, replace the camshaft timing oil control valve assembly.

HINT:

If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.