Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068449 CAMSHAFT OIL CONTROL VALVE G

2TR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Start and warm up the engine.


e.

Idle the engine.


f.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VVT System (Bank 1).


g.

Operate the camshaft timing oil control valve using the intelligent tester, and then check the engine speed.

OK:
Tester Operation Specified Condition
Camshaft Timing Oil Control Valve OFF Normal engine speed
Camshaft Timing Oil Control Valve ON Engine idles roughly or stalls soon after camshaft timing oil control valve switched from OFF to ON


If the result is not as specified, check the camshaft timing oil control valve, wiring and ECM.