Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › THROTTLE BODY › 2011.07–2013.08
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068450 THROTTLE BODY A

2TR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 2.REMOVE INTAKE AIR CONNECTOR

a.

Disconnect the vacuum hose.


b.

Disconnect the No. 2 PCV hose.


c.

Loosen the 2 hose clamps, and then remove the 2 bolts and intake air connector.


Hide 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Disconnect the throttle position sensor and control motor connector.


b.

Disconnect the 2 water by-pass hoses.


c.
A086829

Remove the 2 bolts, the 2 nuts and the throttle body with motor assembly.


d.

Remove the gasket from the intake manifold.