Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068452 ACCELERATOR PEDAL A

2TR-FE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE ACCELERATOR PEDAL ROD ASSEMBLY

a.
A301374

Disconnect the accelerator pedal position sensor connector.


b.

Remove the 2 bolts and accelerator pedal rod assembly.

NOTICE:
·

Prevent physical shocks to the accelerator pedal rod assembly.

·

Do not disassemble the accelerator pedal rod assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal rod assembly.

If applied, the accelerator pedal rod assembly must be replaced.