Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068453 MASS AIR FLOW METER G

2TR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 1.INSPECT MASS AIR FLOW METER

a.
A207208
1.01,0.667 0.604,0.792 0.604,0.792 0.604,1.542 true 1.01,0.813 0.604,0.927 true 0.542,1.583 0.833,1.802 0.292,0.219 10 false *1
*1 Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.


b.
A207209
2.573,1.188 2.708,0.719 2.708,0.719 2.823,0.719 true 1.979,1.677 2.115,1.677 2.115,1.677 2.385,1.375 true 1.74,1.625 2.042,1.854 0.302,0.229 10 false E2 2.865,0.625 3.26,0.854 0.396,0.229 10 false THA

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 5 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.493 to 0.667 kΩ


If the result is not as specified, replace the mass air flow meter.