Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068454 CAMSHAFT POSITION SENSOR G

2TR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT CAMSHAFT POSITION SENSOR

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 835 to 1400 Ω
Hot 1060 to 1645 Ω


HINT:

In the table above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the camshaft position sensor.