1.INSPECT NO. 1 INTEGRATION RELAY (MAIN)
Check the EFI fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| EFI fuse | Always | Below 1 Ω |
If the result is not as specified, replace the EFI fuse.
| *a | Component without harness connected
(No. 1 Integration Relay) |
Check the MAIN relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1J-1 - 1J-4 | Battery voltage not applied to terminals 1J-2 and 1J-3 | 10 kΩ or higher |
| Battery voltage applied to terminals 1J-2 and 1J-3 | Below 1 Ω |
If the result is not as specified, replace the No. 1 integration relay.
2.INSPECT NO. 1 INTEGRATION RELAY (C/OPN)
| *a | Component without harness connected
(No. 1 Integration Relay) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1J-5 - 1J-8 | Battery voltage not applied to terminals 1J-6 and 1J-7 | 10 kΩ or higher |
| Battery voltage applied to terminals 1J-6 and 1J-7 | Below 1 Ω |
If the result is not as specified, replace the No. 1 integration relay.