Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068462 HEATED OXYGEN SENSOR G

2TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 1)

a.
A112088
1.26,0.76 0.771,0.76 true 2.667,0.76 2.188,0.76 true 0.771,1.667 0.896,1.667 0.896,1.667 1.271,1.448 true 0.5,0.677 0.781,0.865 0.281,0.188 10 false +B 2.75,0.677 3.24,0.885 0.49,0.208 10 false HT1A 0.5,1.573 0.813,1.781 0.313,0.208 10 false E2 0.115,0.094 0.333,0.271 0.219,0.177 10 false *a
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1A) - 2 (+B) 20°C (68°F) 11 to 16 Ω
1 (HT1A) - 4 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.