Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › SFI SYSTEM
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068463 SFI SYSTEM D

2TR-FE ENGINE CONTROL  SFI SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

2.

Switch the ECM from normal mode to check mode using the tester (See page Engine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>CHECK MODE PROCEDURE).

3.

Perform a simulation test.

4.

Check and wiggle the harness(es), connector(s) and terminal(s).