Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › DRIVE BELT › from 2012.09
RM1880E _51 Engine / Hybrid System _013210 2TR-FE ENGINE MECHANICAL _0068465 DRIVE BELT A

2TR-FE ENGINE MECHANICAL  DRIVE BELT  REMOVAL  


PROCEDURE

Hide 1.REMOVE FAN AND GENERATOR V BELT

a.
A099194

Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.

NOTICE:

When removing the fan and generator V belt, do not use the idle pulley's bolt.


HINT:

After removing the fan and generator V belt, move the tensioner upward as far as possible.



Hide 2.REMOVE TENSIONER PULLEY

NOTICE:

Perform the following procedure when it is necessary to replace the tensioner pulley.


a.

Remove the engine oil level dipstick.


b.

Remove the bolt, engine oil level dipstick guide and O-ring.

NOTICE:

Cover the dipstick guide hole to prevent foreign matter from entering it.



c.
A302379

Remove the bolt, dust seal and tensioner pulley.