Home › Engine / Hybrid System › 2TR-FE ENGINE MECHANICAL › CYLINDER BLOCK
RM1880E _51 Engine / Hybrid System _013210 2TR-FE ENGINE MECHANICAL _0068473 CYLINDER BLOCK A

2TR-FE ENGINE MECHANICAL  CYLINDER BLOCK  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Bore all 4 cylinders to fit the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



PROCEDURE

Hide 1.BORE CYLINDER

a.

Prepare 4 new O/S pistons.


b.
A097953
2.792,1.417 2.958,1.583 0.167,0.167 10 false *1
*1 Distance


Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.

Standard piston diameter (O/S 0.50):

95.440 to 95.450 mm (3.7575 to 3.7579 in.)


Distance:

13.8 mm (0.543 in.)



c.

Calculate the amount each cylinder is to be rebored as follows.

HINT:

Size to be rebored = P + C - H

P = Piston diameter

C = Piston oil clearance: 0.019 to 0.052 mm (0.000748 to 0.00205 in.)

H = Allowance for honing: 0.02 mm (0.000787 in.) or less




d.

Bore and hone the cylinders to the calculated dimensions.

NOTICE:

Excess honing will destroy the finished roundness.



e.

Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.

HINT:

Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)



f.

Finish the cylinder bore using the calculated value.


g.
A101487
1.802,2.688 2.208,2.448 2.208,2.448 2.292,2.448 true 1.917,2.917 2.24,3.229 2.24,3.229 2.302,3.229 true 1.708,3.875 2,4.177 0.292,0.302 10 false (A) 2.354,2.344 2.594,2.552 0.24,0.208 10 false *1 2.354,3.125 2.552,3.313 0.198,0.188 10 false *2
*1 Thrust Direction
*2 Axial Direction
V100135

Front


Using a cylinder gauge, measure the cylinder bore diameter.

Standard oil clearance:

0.019 to 0.052 mm (0.000748 to 0.00205 in.)