Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL PUMP
RM1880E _51 Engine / Hybrid System _013211 2TR-FE FUEL _0068479 FUEL PUMP G

2TR-FE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL PUMP

a.
A302875
0.104,0.115 0.552,0.438 0.448,0.323 10 false *a
*a Component without harness connected
(Fuel Pump)


Check the fuel pump resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 5 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check fuel pump operation.

i.

Apply battery voltage to terminals 4 and 5. Check that the pump operates.

NOTICE:
·

This test must be completed within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always turn the voltage on and off at the battery, not the fuel pump.



If the pump does not operate, replace the fuel pump.