1.REMOVE FUEL SENDER GAUGE ASSEMBLY
2.REMOVE NO. 1 FUEL SUB-TANK
Disconnect the fuel pump connector.
Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps.
Disconnect the 2 fuel tubes and fuel pump harness.
Using a screwdriver, detach the 3 claws from the claw holes.
Tape the screwdriver tip before use.
Using a screwdriver, detach the 2 claws from the claw holes and remove the fuel sub-tank.
Do not damage the fuel sub-tank.
Tape the screwdriver tip before use.
3.REMOVE FUEL PUMP
Using a screwdriver, detach the 3 claws from the claw holes and disconnect the fuel pump and suction filter assembly.
Tape the screwdriver tip before use.
Disconnect the fuel pump connector.
Remove the fuel pump harness.
| *1 | O-Ring |
Remove the O-ring from the fuel pump.