1.INSTALL FUEL PUMP
Install the fuel pump harness.
Connect the fuel pump connector.
| *1 | Supporter |
| *2 | New O-Ring |
| *3 | Fuel Pump |
Apply a light coat of gasoline to a new O-ring, and install the O-ring to the supporter of the fuel suction plate.
Attach the 3 claws to the claw holes and install the fuel pump and suction filter assembly.
2.INSTALL NO. 1 FUEL SUB-TANK
Attach the 2 claws to the claw holes and install the fuel sub-tank.
Attach the 3 claws to the claw holes.
Connect the 2 fuel tubes and fuel pump harness.
Attach the claw on the end of the tube to the claw hole. Connect the tube to the 2 clamps on the fuel sub-tank.
Connect the fuel pump connector.
3.INSTALL FUEL SENDER GAUGE ASSEMBLY