Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY
RM1880E _51 Engine / Hybrid System _013211 2TR-FE FUEL _0068481 FUEL SENDER GAUGE ASSEMBLY G

2TR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A246389
1.594,4.281 0.333,4.281 true 1.271,2.479 0.333,2.479 true 1.229,1 1.354,1.146 0.125,0.146 10 false 3 1.677,1 1.802,1.146 0.125,0.146 10 false 2 2.115,1 2.24,1.146 0.125,0.146 10 false 1 0.188,4.198 0.323,4.344 0.135,0.146 10 false E 0.188,2.396 0.323,2.542 0.135,0.146 10 false F 0.052,0.042 0.24,0.198 0.188,0.156 10 false *a
*a Front view of wire harness connector
(to Fuel Sender Gauge Assembly)


Check that the float moves smoothly between F and E.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Float position is F (upper) 3.0 to 5.0 Ω
Float position is E (lower) 109 to 111 Ω


If the result is not as specified, replace the fuel sender gauge assembly.