Home › Engine / Hybrid System › 2TR-FE EMISSION CONTROL › PURGE VALVE
RM1880E _51 Engine / Hybrid System _013212 2TR-FE EMISSION CONTROL _0068484 PURGE VALVE G

2TR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 26 to 30 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground


HINT:

When measuring the coil resistance, make sure that the surface temperature of the purge VSV is 20°C (68°F).


If the result is not as specified, replace the purge VSV.


b.
A099532
2.406,0.958 2.635,1.156 false 2.625,0.927 2.427,1.177 false 2.229,0.677 2.115,0.677 2.115,0.677 1.844,0.781 false 2.479,1.604 2.354,1.604 2.354,1.604 2.146,1.302 false 2.625,0.208 2.938,0.479 0.313,0.271 10 false *a 2.271,0.604 2.531,0.833 0.26,0.229 10 false *1 2.521,1.531 2.781,1.75 0.26,0.219 10 false *2
*1 Port E
*2 Port F
*a Air


Check operation of the purge VSV.

i.

Check that air does not flow from port E to port F.


ii.
A110272
0.615,1.667 1.063,1.667 false 0.802,2.719 0.802,2.427 false 0.385,1.615 0.563,1.781 0.177,0.167 10 false *1 0.729,2.802 1.01,2.948 0.281,0.146 10 false *2 1.802,0.635 2.083,0.833 0.281,0.198 10 false *a
*1 Port E
*2 Port F
*a Air


Apply battery voltage across terminals 1 and 2.


iii.

Check that air flows from port E to port F.

If the result is not as specified, replace the purge VSV.