Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM1880E _51 Engine / Hybrid System _013213 2TR-FE INTAKE / EXHAUST _0068489 EXHAUST MANIFOLD A

2TR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT UPPER FENDER APRON SEAL

a.

Remove the 6 clips and front upper fender apron seal.


Hide 2.REMOVE FRONT FENDER SEAL

a.

Remove the 5 clips and front fender seal.


Hide 3.REMOVE AIR CLEANER ASSEMBLY

a.
A253352

Disconnect the mass air flow meter connector.


b.

Loosen the hose clamp.


c.

Remove the 2 bolts and air cleaner assembly.


Hide 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


b.

Remove the 4 bolts, 2 nuts and 2 compression springs.


c.

Remove the front exhaust pipe from the exhaust pipe support.


Hide 5.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.

Remove the 5 bolts and No. 1 exhaust manifold heat insulator.


Hide 6.REMOVE MANIFOLD STAY

a.
A252720

Remove the 3 bolts and manifold stay.


Hide 7.REMOVE EXHAUST MANIFOLD

a.
A251810

Remove the 6 nuts and exhaust manifold.


b.

Remove the gasket.