Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM1880E _51 Engine / Hybrid System _013213 2TR-FE INTAKE / EXHAUST _0068490 EXHAUST PIPE A

2TR-FE INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A107610

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

40 mm (1.57 in.)


If the length is less than the minimum, replace the compression spring.


b.

Install the front exhaust pipe to the exhaust pipe support.


c.
A076194
2.031,1.583 1.594,1.885 1.594,1.885 1.479,1.885 true 2.438,0.979 3.042,0.979 true 1.313,1.802 1.656,2.156 0.344,0.354 10 *1 3.083,0.906 3.385,1.198 0.302,0.292 10 *2
*1 Gasket
*2 Wooden Block


Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the exhaust manifold.

NOTICE:
·

Be sure to install the gasket so that it faces the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket.

·

When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.




d.

Connect the front exhaust pipe to the exhaust manifold with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 2.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 1)

Hide 3.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install the center exhaust pipe to the 3 exhaust pipe supports.


b.

Install a new gasket and the center exhaust pipe to the front exhaust pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 4.INSTALL TAILPIPE ASSEMBLY

a.

Install the tailpipe to the exhaust pipe support.


b.

Install a new gasket and the tailpipe to the center exhaust pipe with the 2 bolts and 2 nuts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 5.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the problem areas to stop the leak. Replace damaged parts as necessary.