Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM1880E _51 Engine / Hybrid System _013213 2TR-FE INTAKE / EXHAUST _0068490 EXHAUST PIPE A

2TR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 1.REMOVE TAILPIPE ASSEMBLY

a.

Remove the 2 bolts and 2 nuts.


b.

Disconnect the tailpipe from the center exhaust pipe and remove the gasket.


c.

Remove the tailpipe from the exhaust pipe support.


Hide 2.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts and 2 nuts.


b.

Disconnect the center exhaust pipe from the front exhaust pipe and remove the gasket.


c.

Remove the center exhaust pipe from the 3 exhaust pipe supports.


Hide 3.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 1)

Hide 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts and 2 compression springs.


b.

Disconnect the front exhaust pipe from the exhaust manifold and remove the gasket.


c.

Remove the front exhaust pipe from the exhaust pipe support.