Home › Engine / Hybrid System › 2TR-FE LUBRICATION › OIL PUMP
RM1880E _51 Engine / Hybrid System _013215 2TR-FE LUBRICATION _0068499 OIL PUMP G

2TR-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A087021

Coat the relief valve with engine oil and drop it into the relief valve hole. Check that the oil pump relief valve falls in smoothly by its own weight.

If the valve does not fall smoothly, replace the oil pump relief valve. If necessary, replace the timing chain cover sub-assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

a.
A097981
0.854,0.896 0.458,0.229 0.458,0.229 0.979,0.823 true 0.24,0.115 0.458,0.292 0.219,0.177 10 false *1
*1 Alignment Mark


Install the rotors to the oil pump body with the marks facing outward. Check that the rotors revolve smoothly.


b.
A087023

Check the tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips as shown in the illustration.

Standard tip clearance:

0.040 to 0.160 mm (0.00157 to 0.00630 in.)


Maximum tip clearance:

0.260 mm (0.0102 in.)


If the tip clearance is more than the maximum, replace the timing chain cover sub-assembly.



c.
A087025

Check the side clearance.

i.

Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge as shown in the illustration.

Standard side clearance:

0.025 to 0.075 mm (0.000984 to 0.00295 in.)


Maximum side clearance:

0.130 mm (0.00512 in.)


If the side clearance is more than the maximum, replace the timing chain cover sub-assembly.



d.
A087024

Check the body clearance.

i.

Using a feeler gauge, measure the clearance between the oil pump body and driven rotor as shown in the illustration.

Standard body clearance:

0.025 to 0.325 mm (0.000984 to 0.0128 in.)


Maximum body clearance:

0.425 mm (0.0167 in.)


If the body clearance is more than the maximum, replace the timing chain cover sub-assembly.