1.INSTALL FRONT OIL PUMP OIL SEAL
Using SST and a hammer, tap in a new front oil pump oil seal.
Make sure the front oil pump oil seal end is flush with the outer edge of the pump body.
Coat the lip of the front oil pump oil seal with MP grease.
2.FIX FRONT OIL PUMP BODY
Place the front oil pump body on the torque converter assembly.
3.INSTALL FRONT OIL PUMP DRIVEN GEAR
Coat the driven gear with ATF.
Install the driven gear to the front oil pump body.
4.INSTALL FRONT OIL PUMP DRIVE GEAR
Coat the drive gear with ATF.
Install the drive gear to the front oil pump body.
5.INSTALL STATOR SHAFT ASSEMBLY
Align the bolt holes of the stator shaft with the bolt holes of the front oil pump body and install the stator shaft assembly to the front oil pump body.
Install the 13 bolts.
6.INSTALL CLUTCH DRUM OIL SEAL RING
Coat 2 new clutch drum oil seal rings with ATF.
Squeeze the ends of the 2 oil seal rings together with the overlap distance 8.0 mm (0.314 in.) or less, and then install them to the stator shaft groove.
After installing the oil seal rings, check that they rotate smoothly.
7.INSPECT OIL PUMP DRIVE GEAR ROTATION
8.INSTALL FRONT OIL PUMP BODY O-RING
Coat a new O-ring with ATF and Install it to the front oil pump body.