1.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
|
MP grease |
Apply MP grease to the inside of a new clutch master cylinder push rod clevis bush.
Install the clevis bush to the clutch pedal sub-assembly.
Install the clevis bush from the left side of the vehicle.
2.INSTALL NO. 1 CLUTCH PEDAL CUSHION
Install the No. 1 clutch pedal cushion to the clutch pedal sub-assembly.
3.INSTALL CLUTCH PEDAL BUSH
|
MP grease |
Apply MP grease to the collar and the inside and outside of 2 new clutch pedal bushes.
Install the 2 bushes and collar to the clutch pedal sub-assembly.
4.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
Install the clutch pedal sub-assembly to the clutch pedal support sub-assembly with the bolt and nut.
Install the bolt from the right side of the vehicle.
5.INSTALL CLUTCH PEDAL PAD
6.INSTALL CLUTCH PEDAL ASSEMBLY
Install the clutch pedal with the bolt and 2 nuts.
7.CONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
|
MP grease |
Apply MP grease to the contact surface of the clevis pin.
Connect the clutch master cylinder push rod clevis with the clevis pin and install a new clip.
Connect the clutch pedal spring to the clevis pin and clutch pedal support to install it.
8.INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY
9.INSTALL COMBINATION METER ASSEMBLY
10.CHECK FLUID LEVEL IN RESERVOIR