1.REMOVE COMBINATION METER ASSEMBLY
2.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
Disconnect the clutch pedal spring from the clevis pin and clutch pedal support and remove it.
Remove the clip and clevis pin and disconnect the clutch master cylinder push rod clevis.
3.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY
Remove the bolt, 2 nuts and clutch pedal support assembly.
4.REMOVE CLUTCH PEDAL PAD
5.REMOVE CLUTCH PEDAL SUB-ASSEMBLY
Remove the nut, bolt and clutch pedal sub-assembly from the clutch pedal support sub-assembly.
6.REMOVE CLUTCH PEDAL BUSH
Remove the collar and 2 clutch pedal bushes from the clutch pedal sub-assembly.
7.REMOVE NO. 1 CLUTCH PEDAL CUSHION
Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
8.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
Using SST and a hammer, tap out the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.