Home › Drivetrain › R150 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT
RM1880E _52 Drivetrain _013219 R150 MANUAL TRANSMISSION / TRANSAXLE _0068530 INPUT SHAFT G

R150 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 1.INSPECT NO. 2 SYNCHRONIZER RING

a.
C281918
0.563,0.635 0.875,0.833 0.313,0.198 10 false *a
*a Locks


Apply gear oil to the cone of the input shaft, and check that it does not turn in either direction while pushing the No. 2 synchronizer ring.

If it can turn, replace the No. 2 synchronizer ring.


b.
D026118

Push the No. 2 synchronizer ring against the cone of the input shaft. Measure the clearance between the No. 2 synchronizer ring and input shaft.

Standard clearance:

0.70 to 1.70 mm (0.0276 to 0.0669 in.)


If the clearance is not as specified, replace the No. 2 synchronizer ring with a new one.