Home › Drivetrain › R150 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT › from 2012.09
RM1880E _52 Drivetrain _013219 R150 MANUAL TRANSMISSION / TRANSAXLE _0068530 INPUT SHAFT A

R150 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL INPUT SHAFT FRONT BEARING

D029020
0.938,0.875 0.521,0.604 0.521,0.604 1.042,0.604 true 0.125,0.51 0.458,0.708 0.333,0.198 10 false SST

a.

Using SST and a press, press in a new front bearing to the input shaft.

SST
09950-60010  (09951-00570)
09950-70010  (09951-07100)

NOTICE:

Install the input shaft front bearing so that the snap ring groove is on the front side.



Hide 2.INSTALL FRONT BEARING SHAFT SNAP RING

a.

Select a snap ring so that the clearance between the input shaft and front bearing is within the specification.

Standard clearance:

0.10 mm (0.0039 in.) or less


Snap Ring Thickness:
Thickness
2.10 to 2.15 mm (0.0827 to 0.0846 in.)
2.15 to 2.20 mm (0.0846 to 0.0866 in.)
2.20 to 2.25 mm (0.0866 to 0.0886 in.)
2.25 to 2.30 mm (0.0886 to 0.0906 in.)
2.30 to 2.35 mm (0.0906 to 0.0925 in.)
2.35 to 2.40 mm (0.0925 to 0.0945 in.)
2.40 to 2.45 mm (0.0945 to 0.0965 in.)



b.
D026115

Using a snap ring expander, install the snap ring.


Hide 3.INSTALL INPUT SHAFT BEARING

a.
D026114

Apply gear oil to the input shaft bearing, and install it to the input shaft.