Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY
RM1880E _52 Drivetrain _013220 DRIVE SHAFT / PROPELLER SHAFT _0068534 PROPELLER SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT

a.
C061260

Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

Maximum Runout:
Item Specified Condition
Propeller shaft 0.3 mm (0.0118 in.)
Intermediate shaft 0.5 mm (0.0196 in.)


If the shaft runout is more than the maximum, replace the shaft.


Hide 2.INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY

a.

Clamp the propeller shaft in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Check the spider bearings for wear or damage.


c.
C172298

Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the bearing axial play is more than the maximum, replace the spider bearing.


Hide 3.INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY

a.
F049879

While turning the center bearing by hand, check that it turns smoothly without catching and that there are no cracks or damage.

If there are any defects, replace the center bearing.

If there is any damage to the lip of the center bearing case, replace the center bearing.