Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT
RM1880E _52 Drivetrain _013221 AXLE AND DIFFERENTIAL _0068539 REAR AXLE HUB BOLT A

AXLE AND DIFFERENTIAL  REAR AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 3.REMOVE REAR AXLE HUB BOLT

F102348
2.104,0.833 2.427,0.552 false 1.24,1.354 1.438,1.979 1.438,1.979 1.729,1.979 true 1.583,0.76 2.042,0.302 true 2.052,0.177 2.396,0.438 0.344,0.26 10 false *1 3.01,0.698 3.417,0.948 0.406,0.25 10 false *a 0.667,1.406 1.031,1.698 0.365,0.292 10 false *b 1.781,1.875 2.125,2.135 0.344,0.26 10 false *1 2.49,0.438 2.979,0.771 0.49,0.333 10 false SST
*1 Nut
*a Turn
*b Hold


a.

Temporarily install 2 nuts to the hub bolts as shown in the illustration.


b.

Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt.

SST
09650-17011  


Hide 4.INSTALL REAR AXLE HUB BOLT

F050070
3.052,1.74 3.156,1.875 false 1.573,0.729 2.188,0.333 2.188,0.333 1.948,0.885 true 2.792,1.854 2.156,1.906 true 2.219,0.167 2.521,0.438 0.302,0.271 10 false *2 3.104,1.885 3.396,2.146 0.292,0.26 10 false *2 1.958,1.833 2.292,2.094 0.333,0.26 10 false *1 2.823,0.375 3.146,0.677 0.323,0.302 10 false *a 0.698,1.448 1.031,1.729 0.333,0.281 10 false *b
*1 Washer
*2 Nut
*a Turn
*b Hold


a.

Install a plate washer and nut to a new hub bolt as shown in the illustration.


b.

Using a brass bar or equivalent to hold the axle shaft, install the hub bolt by tightening the nut.


c.

Remove the 2 nuts from the hub bolts.


Hide 5.INSTALL BRAKE DRUM

Hide 6.INSTALL REAR WHEEL

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)