1.REMOVE REAR AXLE SHAFT INNER OIL SEAL
Using SST and a press, press out the oil seal.
2.REMOVE REAR AXLE BEARING INNER RETAINER LH
Using a grinder, grind down the inner retainer and ABS speed sensor rotor.
Using a chisel and a hammer, cut off the inner retainer and rear skid control rotor. Then remove them from the axle shaft.
3.REMOVE REAR AXLE SHAFT BEARING AND OUTER RETAINER
Using SST and a press, press out the bearing from the axle shaft.
Remove the bearing outer retainer.