Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE SHAFT
RM1880E _52 Drivetrain _013221 AXLE AND DIFFERENTIAL _0068540 REAR AXLE SHAFT A

AXLE AND DIFFERENTIAL  REAR AXLE SHAFT  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL REAR AXLE SHAFT BEARING AND OUTER RETAINER

a.
F050076
0.792,1.448 0.5,1.063 0.5,1.063 0.406,1.063 true 0.083,0.99 0.563,1.24 0.479,0.25 10 false SST

Install the bearing outer retainer.


b.

Using SST and a press, press in the retainer and a new bearing to the axle shaft.

SST
09515-21010  


Hide 2.INSTALL REAR AXLE BEARING INNER RETAINER LH

a.
F050077
0.813,1.396 0.583,1.063 0.583,1.063 0.448,1.063 true 0.135,0.948 0.563,1.292 0.427,0.344 10 false SST

Heat a new inner retainer to about 150°C (302°F).


b.

Using SST and a press, press the inner retainer onto the axle shaft while the inner retainer is still hot.

SST
09515-21010  

HINT:
·

Face the non-beveled side of the inner retainer toward the bearing.

·

Be sure that there is no oil or grease on the rear axle shaft or retainer.




Hide 3.INSTALL REAR SKID CONTROL ROTOR

a.
F050078
0.813,1.406 0.51,0.99 0.51,0.99 0.406,0.99 true 0.094,0.896 0.604,1.229 0.51,0.333 10 false SST

Using SST and a press, press in the rear skid control rotor onto the axle shaft.

SST
09515-21010  


Hide 4.INSTALL REAR AXLE SHAFT INNER OIL SEAL

a.
F050079
0.854,1.531 0.563,1.135 0.563,1.135 0.438,1.135 true 0.115,1.031 0.667,1.406 0.552,0.375 10 false SST

Using SST and a press, press in a new oil seal to the axle shaft.

SST
09506-30012