Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL OIL
RM1880E _52 Drivetrain _013221 AXLE AND DIFFERENTIAL _0068542 DIFFERENTIAL OIL A

AXLE AND DIFFERENTIAL  DIFFERENTIAL OIL  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

a.

Stop the vehicle on a level surface.


b.

Remove the differential filler plug and gasket.


c.

Remove the drain plug and gasket, and drain the oil.


d.

Install a new gasket and the drain plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 2.ADD DIFFERENTIAL OIL

a.
D025304
0.698,1.323 1.073,1.635 0.375,0.313 10 false *a
*a 0 to 5 mm (0 to 0.196 in.)


Add differential oil so that the oil level is within 5 mm (0 to 0.196 in.) from the bottom lip of the differential filler plug hole.

NOTICE:
·

After changing the oil, drive the vehicle, and then check the oil level again.

·

Too much or too little oil will lead to differential problems.



If necessary, fill the differential carrier with hypoid gear oil.

Differential oil type:

Hypoid gear oil API GL-5


Recommended Viscosity:
Temperature Viscosity
Above -18°C (0°F) SAE 90
Below -18°C (0°F) SAE 80W-90 or SAE 80W


Standard Rear Differential Oil Capacity:

3.00 to 3.10 liters (2.84 to 2.93 US qts., 2.64 to 2.73 Imp. qts.)



b.

Check for oil leakage when the oil level is low.


c.

Install a new gasket and the differential filler plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)