Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM1880E _53 Suspension _013223 FRONT SUSPENSION _0068547 FRONT SHOCK ABSORBER A

FRONT SUSPENSION  FRONT SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

C113157

a.

Remove the nut and disconnect the stabilizer link from the lower arm.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 3.DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 6.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING

F049906

a.

Remove the nut and bolt.

HINT:

While fixing the nut in place, loosen and remove the bolt.



b.
F049907

Remove the 3 nuts and shock absorber with coil spring.


Hide 7.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

a.
F049908
2.688,1.625 2.5,1.625 2.5,1.625 2.313,1.833 false 2.75,1.531 3.146,1.729 0.396,0.198 10 false SST

Secure SST in a vise.

SST
09727-30022  (09727-00010, 09727-00021, 09727-00031)


b.
C275706
0.208,0.135 0.521,0.292 0.313,0.156 10 false *a 0.271,2.542 0.583,2.698 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Attach the arm of SST to the diameter of the coil spring.

CAUTION:
·

Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.

·

Make sure that the claws of the hooks are securely attached.




c.

Using SST, compress the coil spring.

CAUTION:
·

If the coil spring bends during the compression, immediately stop the compression and reinstall SST.

·

Do not compress the spring until the coil springs contact each other.

·

Do not use an impact wrench.




d.
F049909

Hold the shock absorber rod and remove the nut.

NOTICE:

Do not use an impact wrench. It will damage the shock absorber rod.



Hide 8.REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER

a.

Remove the cushion retainer from the shock absorber.


Hide 9.REMOVE FRONT SHOCK ABSORBER CUSHION

a.

Remove the cushion from the shock absorber.


Hide 10.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH

a.

Remove the suspension support from the shock absorber.


b.

Remove the cushion retainer from the shock absorber.


Hide 11.REMOVE FRONT COIL SPRING UPPER INSULATOR LH

a.

Remove the upper insulator from the coil spring.


Hide 12.REMOVE FRONT COIL SPRING LH

a.

Remove the coil spring from the shock absorber.