Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM
RM1880E _53 Suspension _013223 FRONT SUSPENSION _0068548 FRONT UPPER SUSPENSION ARM A

FRONT SUSPENSION  FRONT UPPER SUSPENSION ARM  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT FLEXIBLE HOSE

a.
C237858

Remove the bolt and disconnect the front flexible hose.


Hide 3.REMOVE FRONT UPPER SUSPENSION ARM ASSEMBLY LH

a.
C237859

Support the front axle with a jack.


b.

Remove the clip and nut.


c.
F049916
2.094,1.323 2.51,1.323 2.51,1.323 2.729,1.5 false 2.646,1.552 3.083,1.771 0.438,0.219 10 false SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  


d.
F049917

Remove the 2 nuts and 2 bolts.


e.

Remove the upper arm.


Hide 4.REMOVE FRONT UPPER SUSPENSION ARM BUSH

a.
F049918

Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustration.


b.
F049919
1.25,1.417 1.823,1.969 1.823,1.969 1.115,1.573 true 2.396,0.958 2.396,0.594 2.396,0.594 2.542,0.594 false 1.688,0.156 1.521,0.156 1.521,0.156 1.188,0.906 false 1.896,1.917 2.458,2.115 0.563,0.198 10 false SST 2.625,0.51 2.906,0.708 0.281,0.198 10 false *1 1.74,0.063 2.229,0.292 0.49,0.229 10 false SST
*1 Bush


Using SST and a press, press out the upper arm bush.

SST
09613-26010  
09710-22021  (09710-01061)
09950-00020  


Hide 5.REMOVE UPPER BALL JOINT DUST COVER

a.

Remove the dust cover set ring and dust cover from the upper arm.

NOTICE:
·

Do not damage the ball joint dust cover.

·

If the ball joint dust cover is damaged, replace it.




Hide 6.REMOVE FRONT UPPER BALL JOINT

a.
C237639

Using a snap ring expander, remove the snap ring.


b.
C237640
0.594,0.844 1.26,0.302 1.26,0.302 1.583,0.302 true 0.865,2.333 0.667,2.333 0.667,2.333 0.469,1.771 false 0.958,2.24 1.365,2.438 0.406,0.198 10 false SST 1.656,0.208 2.063,0.406 0.406,0.198 10 false SST

Using SST and a press, press out the upper ball joint.

SST
09612-30012  
09388-40010