Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM1880E _53 Suspension _013223 FRONT SUSPENSION _0068549 FRONT LOWER SUSPENSION ARM G

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

G021680

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.29 to 4.5 N*m (3 to 46 kgf*cm, 3 to 40 in.*lbf) or less



c.

Check for any cracks and grease leaks on the ball joint dust cover.