Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM1880E _53 Suspension _013223 FRONT SUSPENSION _0068550 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

F049932

a.

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Turning torque:

0.05 to 1.96 N*m, (0.5 to 20 kgf*cm, 0.4 to 17 in.*lbf) or less



c.

Check for any cracks and grease leaks on the ball joint dust cover.